Setting The Volume - AUDIOropa pro:ton SP-100S Mode D'emploi

Transmitters and the receivers intended for their
reception must be set to the same channel group.

2.5 Setting the volume

The volume can be adjusted between »VOL 00«

to »VOL 09« by simply pressing the » « and
»  « buttons at any time.
2.6 MIC and AUX inputs
The MIC input serves to connect a microphone
with a 3-pole 3.5 mm jack plug. Input AUX is in-
tended as line-in for analogue audio signals (ste-
reo or mono).
Both inputs may be used at the same time. This
makes it, for example, possible to underline spo-
ken commentary with music.
Through this feature, the speaker can be used as
a voice amplifier, even without the microphone
transmitter SP-100M.
The level of the audio signal at the AUX input
must be adjusted via the audio source. An indi-
vidual adjustment of both inputs is not possible
via the SP-100S.
2.7 Power supply / recharge
The device is equipped with a rechargeable lithium-
ion battery of 7,4 V / 1700 mAh.
To charge the battery, plug the USB charging
cable into the USB socket of the SP-100S and
connect it to a regular USB port (computer, lap-
top, USB power supply).
The red charging status LED is lit during recharge.
16 English