ETI RK-72-850-MV-DE Mode D'emploi page 3

Remove the original sockets and insert the wired shunted
7
sockets into the existing fixture brackets.
For electrical connections see the respective electrical
8
connections step in the Installation Strip Light section of
this manual.
WaRninG: Carefully read and understand the information given in this manual before beginning the assembly and installation. Failure to do so could lead to electric shock, fire,
or other injuries which could be hazardous or even fatal. • Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the circuit breaker.
• Risk of fire or electric shock. Installation of this LED Retrofit Kit requires a person familiar with the construction and operation of the light fixture's/luminaire's electrical system
and the hazard involved. If not qualified, do not attempt installation. Contact a qualified electrician. • Install only in luminaires (light fixtures) that have the construction features and
dimensions shown in the photographs and/or drawings included in these installation instructions and where the input rating of the retrofit kit does not exceed the input rating of the
luminaire. • The retrofit kit is accepted as a component of a luminaire where the suitability of the combination shall be determined by authorities having jurisdiction. • To prevent
wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects. • Installers should not disconnect existing wires from lampholder terminals to make
new connections at lampholder terminals. Instead installers should cut existing lampholder leads away from the lampholder and make new electrical connections to lampholder lead
wires by employing applicable connectors.
nOTiCE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna, increase the separation between the equipment and the receiver, connect the equipment into an outlet on a circuit different from that to which
the receiver is connected, and consult the dealer or an experienced radio/TV. • Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
nOTiCE: Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation. • This device is not intended for use with emergency exits.
See website for Warranty, Troubleshooting or Care and Cleaning details at www.ETiSSL.com.
C
9
10
Questions, problems, missing parts? Call ETiSSL Customer Service 8 a.m. - 5 p.m., CST, Monday - Friday
1-855-eTI-SSLI (1-855-384-7754) www.eTiSSL.com
C
Insert the end of the LED tube labeled "L" into the wired socket with the hot/live (black) wire connected and
turn the tube a quarter turn to lock it in place.
Affix the UL Safety Sticker in a visible location.
CaUTiOn: If installing more than one LED tube in the fixture, make certain that all hot/live (L)
connections are made at the same end of the side-by-side tubes.
If applicable, reattach the lens to the fixture.
Restore power at the electrical panel.
Turn on the light switch to activate the fixture.
A
G
D