ORORO CALGARY Guide De L'utilisateur page 5

OPERATING INSTRUCTIONS
Charge both batteries fully before first use. The LED
light on the charger should turn green from red when
the batteries are fully charged.
Pull out power connector and insert it into the
port on the battery.
Put the battery in the zipper pocket.
To activate, press and hold the power button for
3 seconds. Gloves will start pre-heating with
Orange LED light blinking (for 5 minutes).
Then it will automatically adjust to medium heat
(two orange LEDs).
4
To turn off, press and hold the power button for
3 seconds until LEDs turn off.
ENGLISH