Set Radio Memory; Clock; Local Time - Eton ego 4000 Guide D'utilisation

Notes:
• For better FM reception, pull out the FM rod antenna to its full length.
• While listening to stereo FM broadcasting, if the signal is strong enough,
"ST" indicator will appear on the LCD display. If reception is poor or noisy,
you may press SAS/+10/St/Mono button to turn it to mono broadcasting.
When mono is selected, reception will be better, and "MONO" appears on
LCD display.
4. Press Volume (-/+) buttons to adjust volume to a comfortable listening
level.
5. Press button to turn off the radio.
STORING RADIO STATIONS IN MEMORY
You can store up to 12 FM stations in memory: 4 each in FM1, FM2 and FM3.
Follow the steps below to set radio memory:
1. Press Tuner button repeatedly to turn on the radio and select the band.
2. Press or
desired station.
3. Press and hold one of the memory buttons (Preset 1 through 4) for about 3
seconds. The PRESET icon will be shown on LCD briefly.
Repeat steps 1 to 3 to set other radio station memories.

CLOCK

SET LOCAL TIME
Once the power supply is connected, the LCD shows "SAT 12:00 2000 1 1" :
Following the steps below to set local time and date:
1. Press Set button. The hour indicator flashes.
2. Press Up or Down button to select correct hour number.
Note: If it was after noon, PM indicator would be shown on LCD.
3. Press Set button again to save. Minute indicator starts flashing at the same time.
4. Press Up or Down button to select correct minute number.
5. Press Set button again to save. Year indicator flashes.
6. Press Up or Down button to select correct year number.
7. Press Set button again to save. The month indicator flashes.
8. Press Up or Down button to select correct month number.
9. Press Set button again to save. The day number indicator flashes.
10. Press Up or Down button to select correct date number.
11. Press Set button again to save. The week indicator illuminates. The
time/date setting is complete.
O P E R A T I O N
button or EQ/Prog and Mode/Dir button to tune the
18
G U I D E