Going Away On Vacation - Greenway GWD5570WBC Guide D'utilisation Et D'entretien

Going Away on Vacation

When not using the dispenser for long periods of time or when going on vacation, conserve energy, unplug the dispenser
and drain the reservoirs (see Draining the Reservoirs). Follow Initial Product Cleaning Procedures upon return and
startup of the dispenser.
SPECIFICATIONS
GWD5570WBC
Heating Temp (approx.):
Cooling Temp (approx.):
Output per hr:
Internal Tank:
Power Consumption:
t
rOubLeshOOting
Problem
Water dispenser or
dispensing button is
leaking
Water is not hot or cold
enough
6
Hot
1.2 gal / 4.6 L
0.2 gal / 0.65 L
1220 W
t
ips
Possible Cause
Small pin hole or crack in the bottle,
(common with recycled water bottles).
Drain cap and silicone seal are not secure.
Water was poured directly into bottle
support collar and overflowed.
Possible air pocket.
All the water in the tank has been used.
The unit is unplugged.
Insta-HOT Feature was not activated.
The circuit breaker in your home is
tripped or the fuse has blown.
Temperature limit tripped.
Thermostat needs to be adjusted colder.
194°F / 90°C
5˚C - 8˚C / 41˚F - 46˚F
Cold
0.5 gal / 2.0 L
0.9 gal / 3.4 L
85-103 W
Suggested Solution
Conduct water bottle leak test outlined on
page 3.
Ensure seal is secure in drain plug and
tighten drain cap.
Drain by pressing dispenser taps.
Press several times to relieve air pocket and
release to re-set valve.
Replace with full bottle and wait; 60 minutes for
water to cool, 3 minutes for water to heat (after
activating "Kettle" feature button).
Plug it into the outlet.
Activate Insta-HOT Feature by pressing the button.
Reset the breaker or replace the fuse.
Wait for 20 minutes to allow the temperature to
cool down and the temperature limit switch will
re-set automatically.
Adjust thermostat between min (cool) and max
(colder) levels to achieve desired temperature.
7