DWT KGS12-210 Notice Originale page 26

Alignment of the vertical cutting angle (see fig. 24)
• Loosen lock lever 1�
• Set the cutting angle by tilting the power tool body�
Indicator 48 shows the set cutting angle on scale 2�
• Tighten lock lever 1�
Cutting (see fig. 25)
• Place the power tool on the worktable and prefer-
ably fix it with bolts or cramps.
• If the power tool is equipped with extension
brackets 26, adjust their length depending on the
length of the processed blank�
• Set the desired cutting angles as described above�
Caution: if you are going to do the cut-ing with
body tilt and turn at the same time, first set the tilt
angle and then the turn angle.
• Turn on the indicating laser, If your power tool is
equipped with a kerf indicating laser�
• Set the blank and fix it using cramp 22�
• Turn on the power tool, allow saw blade 5 to reach
the full rotation speed�
• Smoothly pull the body down and make the cut�
While cutting, do not cross your hands and keep them
at a safe distance from saw blade 5 (see fig. 25).
• Turn off the power tool and wait until saw blade 5
stops completely�
• Lift the power tool body up smoothly�
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Replacement of the insert (see fig. 26-27)
• Replace the worn or damaged insert 17 in due time�
• Turn off screws 50 (see fig. 26-27).
The manufacturer reserves the possibility to introduce changes.
• Replace the worn insert 17�
• Tighten screws 50�
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 23�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com�
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
26
Transportation
of the power tools
Environmental
protection