Publicité
6
Secure credenza to wall
(2) 8-32 x 1/2" PH
thread cutting screws
7
Install wall brackets on display stand
D i s
p l a
y S
t a n
d
#8 x 1-1/4"
PHSM screw
(2 req'd)
Wall
bracket
(2) #14 x 1-3/4"
PHSM screws
or
(2) 1/4 x 1-1/4"
Tapcon hex
slotted screws
W a
l l
Wall bracket
w/ 3/16" slot
Note: Credenza must be anchored
securely to wall studs or a solid wall.
Wood and masonry screws are provided.
0100167
(6) 0101381
8-32 x 1/2" PH
#14 x 1-3/4" PHSM
thread cutting screws
(wood or steel studs)
1. Position the credenza at the preferred location along the wall.
2. Locate wall framing (studs).
3. Attach each wall bracket securely to the credenza with the mounting
holes centered at the wall stud locations. Multiple horizontal positions
and (3) sets of holes are available to locate each wall bracket on a stud.
4. Slide the credenza up to the wall so the wall brackets contact the
wall. Make sure the credenza is sitting level on the floor. If not sit-
ting level, the glides can be adjusted to level.
5. Using the brackets as a template, drill suitable holes in the wall for
the fasteners.
6. Secure each bracket to the wall with (2) wall fasteners.
Note: Display stand must be anchored securely
to wall studs or a solid wall. (2) #8 x 1-1/4"
PHSM screws are provided for wood use.
Wall fasteners
Drill bit
Wall fasteners
(6) 055699
1/4" x 1-1/4" Tapcon
hex slotted screw
(masonry use)
(2) 026436
#8 x 1-1/4" PHSM
screw
0191542R3 Page 4 of 7
Publicité
