Sunex Tools 8005SC Mode D'emploi page 2

ASSEMBLY INSTRUCTIONS FOR LOCKING DRAWER
Examine box contents, then proceed with following instructions.
Tools Needed for Assembly: Hardware included for attaching drawer to cart:
(6 per unit) (6 per unit) (12 per unit) (4 per unit)
®
3/16" 14 mm Step 8: With the cart fully assembled, take a small punch
#3 Phillips Head
punch and hammer, and gently knock out the 4 pre-scored dimples
Screwdriver
in the top tray.
Step 9: Turn the cart on its handles as shown in drawing B. You will
2
see the 4 holes that you knocked out.
Step 10: Disassemble the locking drawer (if not already
1B
1A
disassembled) by removing all bolts. Product must match illustration
A before proceeding to Step 11.
Step 11: Line up the holes on the back of the shelf with part #1A,
the left side of the drawer cabinet as shown in drawing B. Part 1A
and 2 overlap and connect as shown in drawing C. Insert bolts and
washers from underneath the shelf and washers and nuts on other
3
side. Do not completely tighten the nut at this time.
Step 12: Line up the holes on the back of the shelf with part #1B,
the right side of the drawer cabinet and the other end of part #2,
the back plate of the drawer cabinet. Insert bolts and washers from
underneath the shelf and washers and nuts on other side. Do not
completely tighten the nut at this time.
Step 13: Line up the holes on part #3, the front panel of the drawer
cabinet, with the other end of 1A, 1B, and the front end of the shelf.
Place part #3 under 1A & 1B, and attach to the shelf. Insert bolts and
washers from underneath the shelf and washers and nuts on other
side. Do not completely tighten the nut at this time.
Step 14: Turn the cart back on its casters.
Step 15: Attach the handle to the front of the drawer with the 4
screws provided. The 4 holes on the front of the drawer have already
been drilled out for you.
Step 16: Before inserting the drawer into the service cart cabinet,
make sure the roller bearing case is extended all the way out to
the black plastic end stop. (This ensures proper alignment during
insertion.) Hold the roller bearing case in place while inserting drawer.
If necessary, adjust the drawer rails (items 1A and 1B) to allow the
drawer to slide on smoothly. Once you have determined the width
which allows the drawer to slide in and out smoothly refer back to
steps 11, 12, and 13 to tighten the nuts down completely.
CAUTION: DO NOT FORCE THE DRAWER
ONTO THE SLIDE RAILS.
This may cause permanent damage to the
slide roller bearings.
Finished Cart
8005SC 2 Rev. 09/09/19