DWT STS06-65 DV Notice Originale page 21

tool� The base plate 13 of the power tool contains
a scale 23 which marks the angles of the casing of
the power tool (the step is 15° or(and) 20°)� If ad-
ditional measuring instruments are used, one may
position the casing of the power tool at any angle
(within the limits specified in the technical data
table)�
• Use Allen key 15 to loosen bolt 22 (see fig. 7.1).
• Shift the base plate 13 back or forward (depending
upon the previously installed angle of the casing) and
select the needed angle of the casing using the read-
ings of the scale 23 or the readings of the additional
measurement instrument (see fig. 7.2-7.3).
• Use Allen key 15 to tighten bolt 22�
• Perform sawing as described above�
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 12�
The manufacturer reserves the possibility to introduce changes.
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com�
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging should
be sorted for environment-friendly recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
21
Transportation
of the power tools
Environmental
protection