EnGlish
8
-
The steam light flashes to indicate that the steam generator is heating up. After 2 minutes the
appliance is ready for use. You hear two beeps, the steam light stops flashing and stays on. Press
the steam trigger for steam.
-
To remove stubborn creases, you can use the steam boost function. Set the temperature dial
between 3 and MAX. Press the steam boost button.
Never direct the steam at people.
9
Press the steam button to select the desired steam setting (Fig. 13).
-
High setting for high steam output (set a temperature from 3 to MAX)
-
Medium setting for moderate steam output (set a temperature from 3 to MAX)
-
ECO setting for environment-friendly steam output (set a temperature from 2 to MAX).
Note: If you do not use the iron for more than 10 minutes, the appliance switches off automatically for
safety reasons. The automatic shut-off light flashes. To switch on the appliance again, press any
button (Fig. 14).
Cleaning
This appliance is equipped with an Auto Calc Clean function. Over time, scale particles build up
inside the steam generator. The appliance automatically performs a Calc Clean process to clean itself
from scale after using 6 to 8 tanks of water.
1
When the Auto Calc Clean process takes place, the Auto Calc Clean light flashes and you
hear short beeps. (Fig. 15)
-
Wait approximately 2 minutes for the appliance to complete the process.
-
During this process, the appliance occasionally produces pumping and clicking sounds.
2
When the Auto Calc Clean process is completed, the Auto Calc Clean light goes off.
The Calc Clean tank light flashes (Fig. 16).
,
3
Remove the water tank (Fig. 17).
-
Press the Calc Clean tank emptying button and empty the Calc Clean tank into the sink.
4
Refill the water tank and reattach it to the steam generator (Fig. 18).
-
The Auto Calc Clean process is now finished and you can start ironing when the steam light is
on continuously.
Note: If you do not empty the Calc Clean tank, the tank will overflow during the next Auto Calc Clean
process.
manual Calc Clean process
The Auto Calc Clean system keeps the appliance sufficiently clean. Hovewer, you can also perform
the Calc Clean process manually for additional cleaning.
1
Fill the water tank to the maximum level (Fig. 19).
2
Put the mains plug in an earthed wall socket (Fig. 11).
3
To start the Calc Clean process manually, keep the middle steam selection button pressed
while switching on the appliance at the same time. Release the steam selection button only
when the blue Auto Calc Clean light flashes (Fig. 20).
4
Follow steps 1-4 of the Auto Calc Clean process described above.
Note: The manual Calc Clean process can only be activated if the appliance is sufficiently cold. If the
appliance is too hot for the manual Calc Clean process, the steam selection button flashes and the
appliance continues to heat up for use.