Operation; To Do Before Operation; To Adjust The Saddle; The Gears - Kayoba LADY'S BIKE Traduction Des Instructions D'origine

3.5.2 To fit the left pedal
1
Turn the pedal counter-clockwise, on the opposite
side of the chain side of the crank arm.
2
Tighten with a 15 mm combination spanner.
(Figure 4)
4

Operation

4.1 To do before operation

● Make sure that the product is adjusted correctly.
(Figure 5)
● Make sure that the product is assembled with brakes and
a bell.
● Make sure that the product has a front lamp with a white
light and a rear lamp with a red light. Make sure that the
lamps can lit.
● Do a check that the reflectors of the product are correctly
installed, clean and not obscured. Replace damaged
reflectors.
● Learn how to use the components and accessories on
the product correctly. If you do not learn how to use the
brakes on the product you can get seriously injured.
● Make sure that the brakes stop the wheels when applied.
Make sure that the brake pads are not worn out.
● Make sure that all screw and components are tight and
correctly installed.
● Make sure that the wheels are correctly installed in the
front fork and the rear fork.
● Make sure that the rims are not damaged.
● Make sure that the tyres are not damaged. Make sure that
the tyres have the correct air pressure.
● Make sure that the steering moves correctly.

4.2 To adjust the saddle

● Make sure that the saddle is comfortably adjusted.
4.2.1 To adjust the height of the saddle
1
Open the quick-release lever (A) on the saddle tube.
(Figure 6)
2
Move the saddle post to the required height (B).
3
Close the quick-release lever.
2022_001
Note! Make sure that the marking for the top position on the
saddle is below the edge of the saddle tube.
4.2.2 To adjust the saddle horizontally
1
Release the knot that holds the saddle to the saddle
post.
2
Adjust the position of the saddle forward or rearward.
Move the saddle with small adjustments to find the
correct position.
Note! If you have you foot on the pedal with the crank arm
horizontal, the pedal should stay below the knee.
3
If it is necessary, adjust the angle of the saddle.
4
Tighten the knot that holds the saddle to the saddle
post.

4.3 The gears

The product has 3 hub gears. The shift lever on the right side
of the handlebars indicates which gear is engaged; 1, 2 or 3.
(Figure 11)
● Make sure that the gears are correctly adjusted.
4.3.1 To change gear
● Turn the inner part of the right handle on the handlebar
to change gear.)

4.4 The brakes

Warning! Do not use a product with brakes that do
not work correct.
● The product has a hub brake at the rear. That is engaged
by pedalling rear.
● The product has a rim brake at the front. There is a brake
handle on the left side of the handlebars that applies the
front brake.
4.4.1 To use the brakes
● Apply the rear brake before you apply the front brake.
Warning! Do not apply the front brake when you turn
the product or on a slippery surface.
23