Publicité
Les langues disponibles
Les langues disponibles
Simeon 900AU Receiver/ Amplifier
Figures 1 & 2
1
FM Soundfield
5
6
8
9
10
11
Simeon Omnipanel 900 Flat Panel Loudspeaker
Figures 3 & 4
2
1. Power ON/OFF switch
with power indicator
2. Display Screen
2
3
4
3. Cursors
4. Volume Control
5. Screw-adjust tone con-
trol (Bass & Treble)
6. Peripheral Volume
Control
AUX IN & PC IN
7
7. Set Button
8. Peripheral Input
AUX IN & PC IN
9. Radio Antennae Plugs
(A & B)
10. Speaker Output (1 & 2)
11. Auxiliary Output with
gain and equalizer
12. Charger power output
(5V)
12
13
13. Power adapter plug
(18V)
14. Speaker Panel
15. Exciters (Piezoelectric
Drive Elements)
16. Receiver Input
17. Mount
18. Fastening Knob
14
Setup
Simeon 900AU Receiver/ Amplifier
The 900AU has one or two FM receiver modules, an integrated amplifier, and
multiple inputs and outputs to connect to the other audio and FM devices. It is
the heart of the entire sound system.
The receiver unit itself requires no special installation, but should be placed in
a suitable, safe location. This could be shelving, well within reach of the speaker
cables and sufficiently close to a classroom power outlet. Identify the correct
power adapter for the receiver and plug it into the power adapter plug [13].
Connect the two antennae to the connectors on the rear panel [9]. Adjust each
antenna to the vertical position for best reception.
Omnipanel 900 Flat Panel Loudspeaker
The new Omnipanel 900 gives great acoustic performance and outstanding
speech intelligibility in a small, efficient format. The flat panel speaker can be
mounted almost anywhere, and to cover extra large spaces like an auditorium a
second panel speaker can be added to the system.
The Omnipanel 900 can either be set up on a tripod floor stand or it can be
wall mounted. Simply slot the Speaker Mount [17] onto the top of either the
Floor Stand or the Wall Mount after they are in place. Tighten the Fastening Knob
[18] to ensure the safety of the Omnipanel. Make sure not to over-fasten the
knob, as this may cause damage to the Floor Stand or Wall Mount. Use only
the included Speakon cable to connect the Omnipanel to the Receiver. Connect
the cable into the back of the Receiver [10] and rotate it to the right to lock it in
place. Do the same on the back of the Omnipanel [16]. To unplug the cable pull
down on the Speakon "Quick Lock", rotate the cable to the left and disconnect it.
Simeon 7LT FM Transmitter
The 7LT transmitter has 96 channels available on a new UHF frequency band
to allow for the best possible sound quality and performance.
Open the transmitter battery compartment [28] and insert the rechargeable
batteries supplied, taking care to observe correct battery polarity.
posable (alkaline) batteries in combination with the charging system.
can be charged using either the HDC-707 or the HDC-702 Transmitter Charging
15
Cradles [Figures 11, 12].
16
17
18
Never use dis-
The 7LT
3
Publicité
