Publicité
Les langues disponibles
Les langues disponibles
SECTION 2 - DEVICE INSTALLATION
1. Place the tripod on a flat, stable and
hard surface. Pull out the tripod legs
to the desired length and lock with the
locking pin.
2. Set the tripod in an upright position
and fully spread the legs.
3. Make sure the feet are on firm ground
and can support the load.
4. Adjust the length of the legs so that
the head is located in the horizontal
plane.
5. The tripod should be positioned over
opening so working line will be located
approximately in the center of the ope-
ning.
6. Make sure that locking pins are pro-
perly secured with the end of the locking
pin that must protrude above the surface
of the tripod legs.
7. Secure the tripod legs with the chain
against the accidental sliding open. The
ends of the chain must be fastened with
a snap hook. The chain should be tight
between the legs of the tripod. Remove
excess slack of the chain.
MAXIMUM LOAD TRANSMITTED FROM THE 27961 TO THE STRUCTURE / LOADING
DIRECTION Surface, where the 27961 safety tripod was placed on must support the max. device load
of 12 kN. Loading direction: perpendicular to the surface on which the 27961 safety tripod is placed.
SECTION 3 - PERSONAL PROTECTION ACCORDING
TO EN 795/B
The 27961 safety tripod can be used as a temporary anchorage
according to EN 795/B.
27961 provides protection for maximum one person at the
same time.
27961 is equipped with seven attachment points used for per-
sonal protection:
(1) central attachment point
(2) side attachment point
(3) leg attachment point
27961
27961
27961
.
(2)
(1)
(3)
(3)
(3)
EN
Publicité
