Operation; Before Turning Key And Pull Starting Engine - DK2 POWER OPC503V Guide De Montage

OPERATION

BEFORE TURNING KEY & PULL STARTING ENGINE
CLEAR AREA OF ALL PEOPLE AND PROPERTY THAT COULD BE DAMAGED. THINK
SAFETY. CHIPS ARE FLYING PROJECTILES AND CAN CAUSE INJURY.
WEAR SAFETY GLASSES, HEARING PROTECTION, AND GLOVES.
DO NOT WEAR LOOSE FITTING CLOTHES THAT COULD GET STUCK IN THE MACHINE
MOVING PARTS, ONLY CHIP WOOD.
CHILDREN SHOULD NOT RUN THIS EQUIPMENT, STAY ALERT OF YOUR
SURROUNDINGS AND PERSONS THAT COULD APPEAR IN THE CHIP PATH WHILE
YOU ARE WORKING.
UNIT IS DIRECT DRIVE. NO CLUTCH TO SLIP OR BURN UP.
Before starting, make sure all chutes are clear of branches as the cutting wheel will turn
as you pull the recoil starter. Cutter wheel must be free to turn when starting.
PERFORMANCE OPERATION
Feed larger trees up to 3 inches in diameter slowly into the tubular feed chute allowing
the cutter wheel to regain speed. Shoving a tree into the cutter wheel will stall the
machine and damage the cutters or drive shaft.
Feed twigs, leaves, and branches up to 3/8 inch diameter into the top hopper. Wear
gloves, as the cutter will grab the branches and pull them into the machine and from
your hands. NEVER PLACE HANDS INTO THE TOP FEEDER. To clear the top feeder,
turn the key off, remove it, unplug the spark plug. Be safe, the cutters on this machine
are high speed and very sharp.
SET BOTH OF YOUR WHEEL BRAKE PINS TO STABILIZE THE MACHINE DURING
OPERATION. READ AND OBEY ALL WARNING LABELS ON THIS MACHINE.
16