DWT HB03-110 B Notice Originale page 16

Power tool specifications
Power planer
Power tool code
Rated power
Power output
Amperage at voltage
No-load speed
Planing width
Planing depth
Weight
Safety class
Sound pressure
Acoustic power
Weighted vibration
information
Always wear ear protection if the sound
pressure exceed 85 dB(A).
safety rules
WARNING - To reduce the risk of injury,
user must read instruction manual!
WARNING! Read all safety warnings and
all instructions. Failure to follow the warn-
ings and instructions may result in electric
shock, fire and / or serious injury.
Save all warnings and instructions for future refer-
ence.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operat-
ed (cordless) power tool�
Work area safety
• Keep work area clean and well lit. Cluttered or
dark areas invite accidents�
• Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable liq-
uids, gases or dust. Power tools create sparks which
may ignite the dust or fumes�
[127 V ~50/60 Hz]
[230 V ~50/60 Hz]
127 V [A]
230 V [A]
[min
[mm]
[inches]
[mm]
[inches]
[dB(A)]
[dB(A)]
[m/s
Noise
General
[W]
[W]
]
-1
[kg]
[lb]
]
2
• Keep children and bystanders away while oper-
ating a power tool. Distractions can cause you to lose
control�
Electrical safety
• Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any adapter
plugs with earthed (grounded) power tools. Un-
modified plugs and matching outlets will reduce risk
of electric shock�
• Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded�
• Do not expose power tools to rain or wet condi-
tions. Water entering a power tool will increase the
risk of electric shock�
• Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords increase
the risk of electric shock�
• When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of elec-
tric shock�
• If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk
of electric shock� NOTE! The term "residual current
device (RCD)" may be replaced by the term "ground
fault circuit interrupter (GFCI)" or "earth leakage circuit
breaker (ELCB)"�
English
16
HB03-110 B
744269
744238
1100
620
9
4�7
16000
110
4-1/4"
0-3
0"-1/8"
4,5
9�92
92
103
4,1