Installation - Panasonic FV-36RBQL1HD Mode D'emploi Et Notice D'installation

Explanation of symbol word panels
The following symbol word panels are used to classify and describe the level of hazard,
injury, and property damage caused when the denotation is disregarded and improper use
is performed.

INSTALLATION

WARNING
Before installing the Range Hood, carefully read Chap. "GENERAL SAFETY INFORMATION".
CAUTION
The following symbols are used to classify and describe the type of instructions to be
observed.
Note :
The recommended distance between the highest part of the cooker and the lowest part of the Range Hood is
approximately 43 5/16" (1100 mm).
This symbol is used to alert users to a specific operating procedure that
must be followed in order to operate the unit safely.
In certain cases, this distance can be increased up to a maximum of approximately 72" (1829 mm) with a slight decrease
in the efficiency of the device.
The minimum installation distance must not be less than 36" (914 mm).
This symbol is used to alert users to a specific operating procedure that
must not be performed.
Should the instructions for the gas cooker specify a greater distance, take this into consideration.
Install reinforcement wooden frames to hold the ceiling board as shown below in (Fig.
Make a hole in the ceiling as indicated in (Fig.
A
2 "
m i
3 / 8
n .
( 6 0
m m
A l l
)
a r o
u n
d
Joist
1
2
false ceiling ceiling
16
WARNING
WARNING
CAUTION
CAUTION
Denotes a potential hazard that could
The following symbols are used to classify and describe the type of instructions to be
result in serious injury or death.
observed.
The following symbols are used to classify and describe the type of instructions to be
observed.
Denotes a hazard that could result in
This symbol is used to alert users to a specific operating procedure that The ceiling must support the weight of the hood (89 lb. - 40 kg max.).
minor injury.
must be followed in order to operate the unit safely.
This symbol is used to alert users to a specific operating procedure that Install the reinforcement wood frame to hold ceiling board so that ceiling board hold
must be followed in order to operate the unit safely.
This symbol is used to alert users to a specific operating procedure that
load of Range hood.
must not be performed.
This symbol is used to alert users to a specific operating procedure that
must not be performed.
).
2
3
Denotes a potential hazard that could
result in serious injury or death.
Denotes a potential hazard that could
result in serious injury or death.
Denotes a hazard that could result in
minor injury.
Denotes a hazard that could result in
minor injury.
3
3
1
Reinforcement wooden frame
Joist
Joist
2
Cutout dimensions
37" ( 940 mm )
If ceiling is not strong enough to hold
the Range Hood, add reinforcement
wood frame to along the cutout.
Joist
Ceiling
Reinforcement
wooden frame
).
1
1 31/32"
50 mm
Cutout
Ceiling
Reinforcement wooden frame
Cutout