Speedpot Kit Assembly; In Case Of Difficulty - DART Controls 130 CONTROL Serie Manuel D'instructions

SPEEDPOT LO (CCW) (ORANGE)
SPEEDPOT WIPER (RED)
1.250
SPEEDPOT HI (CW) (WHITE)
PROBLEM
Motor doesn't operate
Armature output voltage
cannot be adjusted, output
is a constant DC level
Motor stalls, or runs very
slowly with speed control
turned fully CW
Motor hunts
Repeated fuse blowing
If control still will not operate, go to www.dartcontrols.com/support or call (317) 873-5211.

SPEEDPOT KIT ASSEMBLY

1.240
.500 .370
.250 Dia.
SPEEDPOT
(5K 1/2W)
.437
3/8
5/32
DIA. DIA.
SPEEDPOT LOCATOR HOLE DIMENSIONS

IN CASE OF DIFFICULTY

POSSIBLE CAUSE(S)
- Blown Fuse or Breaker
- Incorrect or no power source
- Speedpot set at Zero
- Worn motor brushes
- No motor or load connected
- Speedpot low connection open
- Low Voltage
- Overload Condition
- Worn motor brushes
- MAX SPEED set incorrectly
- Motor current less than 150Ma
- Too much IR COMP
- Motor is in current limit
- Motor speed is above rated speed
- Max set too high
- Low Voltage
- Overload Condition
- Worn motor brushes
- Defective motor bearings
- Defective electrical components
CUSTOMER'S
MOUNTING BRACKET
DIALPLATE
2.00" dia.
.370
CORRECTIVE ACTION(S)
Replace Fuse or reset breaker
Install proper service
Adjust Speedpot CW to start
Replace brushes
Check that motor or load is connected to
armature terminals
Check that speedpot low wire is connected
Check that VAC is above 100VAC
Reduce load or increase motor size and/or
C.L. setting.
Replace brushes
See ADJUSTMENT PROCEDURE
Motor current must be greater than 150mA
D.C.
See ADJUSTMENT PROCEDURE
See ADJUSTMENT PROCEDURE
Reduce Speed
See ADJUSTMENT PROCEDURE
Check that VAC is above 100VAC
Reduce load
Replace
Replace
Call Dart Distributor or Representative
9
SPEEDPOT
KNOB
HEX NUT
LOCK
WASHER