Setting The Date And Time; Setting The Target Temperature - Austro Flamm Ben Manuel D'instructions

DELETE
SAVE
FEED

Table 13 - Designations of symbols
!
NOTE: With Ben, Percy light and Polly light, you page through the menus to the left or to the right (
and ). However, with Percy and Polly 2.0 you page through the menus from the top to the bottom
( ).

4.3. Setting the date and time

You must set the correct time and date to be able to use the timer functions.
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
 
-
- Set the Hours, Minutes and Day of the week by tapping
setting by tapping

-
''Date''
- Set the Day, Month and Year by tapping
.

4.4. Setting the target temperature

A sensor on the back of the pellet stove measures the target temperature.
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.

-
The screen now shows the currently set ambient temperature (AIR temperature):
- Change the target temperature by tapping
changes immediately.
Delete
Save
Start screw conveyor manually
Indicates which of the icons on the control panel
you have to tap or hold.
 
"Time"
.
67
and/or
and/or . Save your setting by tapping
and/or . The system saves the
english
Tap
Tap
Hold
. Save your