Assemble Bikewing; Operation - Lippert Components Jack-IT BikeWing Manuel D'installation Et D'utilisation

Assemble BikeWing

1. Attach Y-shaped base to Stinger (if necessary) and secure
with NoMotion pin, washers and hairpin cotter pin (Fig.5).
2. Slide one SwayStop™ pin onto each wing starting from
the bottom so the SwayStop is between the snap pin and the
pad (Fig.5). The pins should point in opposite directions.
NOTE: Both the pads and the SwayStop pins slide along
the length of the wings.
NOTE: Two additional SwayStop pins are included as
options if it is desired to secure both bicycle wheels with
pins. If using this option, install additional pins on wings.
3. Attach wings to Y-shaped base using two snap pins (Fig.5).
hairpin
cotter pin
cradle
wing
rubber
strap
pad
Fig.5
lci1.com
rubber
strap
cradle
hairpin
cotter pin
wing
snap pin
Y-shaped base
Stinger
SwayStop pin
snap pin
574-537-8900
Jack-IT
®
Installation and Owner's Manual
(For Aftermarket Applications)
4. Install six or eight rubber straps, including one on each
cradle and one on each SwayStop pin.
5. Attach four cradles, including two on each wing (Fig.5).
Each wing should have one cradle facing forward and one
cradle facing backward.
NOTE: Several hole positions are provided for cradles.
6. Secure cradles with hairpin cotter pins.
NOTE: Adjustment will be necessary depending on the
size and desired position of the bicycles.

Operation

NOTE: For mounting two bicycles, the best technique is
to position the bicycles front-to-back/back-to-front with the
bicycle chain ring to the outside.
1. Hang one bicycle on the inside of the bicycle rack so the
top of each wheel is supported by a cradle.
2. Secure by tensioning each rubber strap over the top of
each tire and engaging a strap hole with the end of the cradle.
3. Using the same fastening technique, utilize one
SwayStop pin to secure one wheel below the frame where
the wheel crosses the wing.
4. If installed, use the additional SwayStop pin to secure
both wheels of the bicycle to the rack.
5. Repeat steps 2-4 for a second bicycle on the other side.
Manual information may be distributed as a complete
document only, unless Lippert Components provides
explicit consent to distribute individual parts.
All manual information is subject to change without
notice. Revised editions will be available for free
download at lci1.com. Manual information is considered
factual until made obsolete by a revised version.
Please recycle all obsolete materials and contact
Lippert Components with concerns or questions.
4
CCD-0002230
BikeWing
™
Rev: 01.03.19