Resources Required; Installation; Attach To Powertower, Bump-It Or Bikebase - Lippert Components Jack-IT BikeWing Manuel D'installation Et D'utilisation

Resources Required

3/4
• Socket wrench with

Installation

Complete installation instructions for the Jack-IT bicycle
rack are detailed in a separate manual on the Customer
Service section of LCI's website. See
www.lci1.com/bike-racks/support-jack-it-bike-racks and
then select Jack-IT Aftermarket Manual from the listed
documents.
Also, from time to time additional Jack-IT options may
become available. See the website for updated information.

Attach to PowerTower, Bump-IT or BikeBase

A lower section of BikeWing will be attached to either
the PowerTower of Jack-IT, the shank of Bump-IT or the
receiver tube of BikeBase. The NoMotion pin should be
3/4
tightened with a " socket wrench until the lock washer is
fully compressed.
Stinger
PowerTower
flat washer
split lock washer
NoMotion
pin
Fig.1
Y-shaped base
hairpin cotter pin
Fig.2
lci1.com
" socket
Jack-IT or go to http://
hairpin cotter pin
split lock
washer
NoMotion pin
flat washer
Bump-IT
574-537-8900
Jack-IT
®
Installation and Owner's Manual
(For Aftermarket Applications)
PowerTower: Insert the Stinger
PowerTower (Fig.1) and secure with NoMotion pin, split lock
washer, flat washer and hairpin cotter pin on the end of the pin.
Bump-It: Insert the end of the Y-shaped base (Fig.2) into
the top of the Bump-It shank and secure with NoMotion
pin, split lock washer, flat washer and hairpin cotter pin on
the end of the pin.
NOTE: Do not install the Stinger in Bump-IT.
BikeBase: Insert the end of the Stinger (Fig.3) or Y-shaped
base (Fig.4) into the top of BikeBase (Figs.3 and 4) and
secure with NoMotion pin, split lock washer, flat washer and
hairpin cotter pin on the end of the pin.
MAKE SURE THE NOMOTION PIN IS PROPERLY
TIGHTENED BEFORE INSTALLING ADDITIONAL
JACK-IT COMPONENTS AND CARGO AND BEFORE
BEGINNING TRANSIT.
flat
washer
split lock
washer
NoMotion pin
Fig.3
hairpin
cotter pin
BikeBase
Fig.4
3
CCD-0002230
BikeWing
™
™ into the top of the
Stinger
hairpin
cotter pin
BikeBase
Y-shaped base
flat washer
split lock
washer
NoMotion pin
Rev: 01.03.19