Operation - Hart HPSV50 20V Manuel D'utilisation

OPERATION

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the following purpose:
 Light-duty vacuuming of dry surfaces
 Household type
INSTALLING/REMOVING BATTERY PACK
See Figures 1 - 2, page 8.
Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place

and the battery pack is secured in the product before
beginning operation.
Depress the latch and pull to release and remove the

battery pack.
 Remove battery and place on the shelf on the wall mount.
Align the raised ribs on the battery with the grooves on
the charger.
 Slide the charger down until it is fully seated on the bat-
tery.
 If charger is kept on the wall mount, use the grooves on
the back of the wall mount to manage the cables and
keep them tidy.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
INSTALLING THE WALL MOUNT
See Figure 2, page 8.
 Choose the desired location for the wall mount.
 Place the mount on the wall at the desired height. Mark
the wall anchor locations. Install the anchors and screw
the mount to the wall.
 Store the vacuum by firmly pressing the unit into the wall
mount to secure.
 Always ensure the vacuum is securely locked into place.
 Accessories can be stored by inserting them from the top
or the bottom of the accessory holder located on the right
side of the wall mount.
STARTING/STOPPING THE VACUUM
See Figure 3, page 8.
 T o start the vacuum: press the ON/OFF button.
 T o stop the vacuum: press the ON/OFF button again.
ECO BUTTON
See Figure 3, page 8.
The vacuum has two speeds to accommodate your clean-
ing needs.
NOTE: The vacuum always starts in high speed.
 P ress the ECO button for LOW speed and the LED indi-
cator illuminates white.
 P ress the ECO button to return to HIGH speed and the
LED indicator illuminates blue.
NOTE: Pressing the ECO switch repeatedly will toggle the
vacuum between the two speeds.
TURNING OFF THE ROLLER BRUSH
See Figure 3, page 8
The roller bar can be used with the roller brush turned off.
To cancel the roller brush:
 Press the roller brush ON/OFF button, located below the
ECO button to cancel the use of the roller brush.
To reactivate the roller brush:
 Press the roller brush ON/OFF button again to turn the
roller brush back on.
NOTE: If vacuum is turned off while the roller brush is off,
when the vacuum is turned back on, the roller brush will
default to the ON setting.
USING THE ROLLER BAR
See Figures 4 - 5, page 9
The roller bar can connect directly to the vacuum for clean-
ing upholstery and stairs or attach with the extension wand
for normal floor vacuuming.
NOTE: When not in use, always store the unit on the wall
mount or lie flat to prevent falling over. Never stand alone in
the upright position. There is a lip located on the handle of
the vacuum that allows it to catch on a surface to prevent
it from slipping.
To connect:
 Switch off unit and remove the battery pack.
 Align the pins on the roller bar with the receptacle in the
stick vacuum or extension wand.
 Press together until it clicks into place.
 Replace battery pack.
5 – English