Assembly; Operation - Hart HPHV33 20V Manuel D'utilisation

SYMBOLS
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
SYMBOL NAME
Recycle
Symbol
V Volts
min Minutes
Direct Current
No Load
n o
Speed
Per Minute
.../min

ASSEMBLY

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-776-5191 for assistance.

OPERATION

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
DESIGNATION/EXPLANATION
This product uses lithium-ion (Li-ion) batteries. Local, state or federal laws may prohibit
disposal of batteries in ordinary trash. Consult your local waste authority for information
r egarding available recycling and/or disposal options.
Voltage
Time
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes, surface speed, orbits etc., per minute
4 – English
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
APPLICATIONS
You may use this product for the following purpose:
 Light-duty vacuuming of dry surfaces
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 7.
Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place

and the battery pack is secured in the product before
beginning operation.
Depress the latch and pull to release and remove the

battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.