Maintenance - Hart HPHV33 20V Manuel D'utilisation

OPERATION
STARTING/STOPPING THE VACUUM
See Figure 2, page 7.
 To start the vacuum: press the ON/OFF button.
 To stop the vacuum: press the ON/OFF button.
INSTALLING ACCESSORIES
See Figure 3, page 7.
The following accessories are included:
Item
Crevice Tool ...........................542291001/542291002
Dust Brush .............................316959001/316959002
Install only accessories designed for use with this vacuum.
 Turn off the vacuum.
 Remove the battery pack.
 P lace the accessory into the port on the nose of the
vacuum.
 Push the accessory securely into place.
 When not in use, remove and store the accessory.

MAINTENANCE

This product contains no serviceable parts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
Part number
NOTE: ILLUSTRATIONS START ON PAGE 7
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
REMOVING/REATTACHING THE DUST BOWL
See Figures 4, page 7.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To remove:
 Remove the battery pack.
 Depress the release button located on top of the hand
vac. Pull the dust bowl down and out.
To reattach:
 Position the two sections as shown. Align the slot on the
bottom of dust bowl with the tab on the bottom of motor
housing, then snap the two sections together.
INSTALLING WALL MOUNT
See Figures 5, page 7.
 Remove the battery pack.
 Secure wall mount with two screws (not included) or
anchors (not included).
NOTE: Make sure the wall mount is secure by finding a
stud or using wall anchors.
 With nose of vacuum pointing up slide the base on the
wall mount as shown for storage.
CLEANING/REPLACING THE FILTER
See Figure 6, page 7.
 Remove the battery pack and the dust bowl.
 Remove dust bowl from hand vac. Pull to remove filter
housing and filter from dust bowl.
 Turn fliter clockwise to remove from filter housing. Turn
clockwise to lock in place.
 Remove the filter from filter housing. Shake or lightly brush
any dust or dirt off the filter.
 Shake or lightly brush any dust off the filter housing. Wash
if necessary.
 Empty the dust bowl; wash if necessary. Before
reattaching to the hand vac, make sure all pieces are
completely dry.
NOTE: Allow 24 hours for parts to dry completely.
When purchasing replacement filter, request recommended
part number 542363001/542363002.
5 – English