Publicité
Les langues disponibles
Les langues disponibles
Auto-Stop
The Recorder incorporates a mechanical auto-stop which automatically disengages
the playback or record functions at the end of a cassette.
This does not operate in either the fast-forward or rewind modes.
If a cassette triggers the auto-stop before reaching the end of the tape, the tape
may have become too tightly wound or has wound ridges, causing too much friction.
This can normally be corrected by rapping the cassette face down on a flat surface
and then winding the tape through, from end to end, in your machine.
Fast-Forward and Rewind
The Fast-Forward key and the Rewind key allow rapid location of a particular
section of tape. Function of either key is canceled by using the Stop key.
Always use the Stop key to halt the tape. Attempting to go from winding to play is
likely to damage the tape, and may cause damage to the mechanism. Do not leave
the machine winding tape in either direction, since the Auto-Stop will not operate
when the tape reaches the end; the mechanism may be damaged if left in this way
for any length of time.
Always use the Stop key once the cassette has wound through to one end.
Protecting Recordings
Normally, anything recorded on the tape is automatically erased when a new
recording is made.
You can protect your recordings from accidental erasure by removing the erase lock
tabs on the rear of the cassette. When the cassette is held with the recorded side
up, the protective tab can be found on the left side of the rear edge of the cassette.
All pre-recorded cassettes are protected in this way to prevent accidental erasure of
the commercial recording.
"Protected" cassettes may be re-recorded by simply fixing a piece of adhesive tape
over the hole where the tap has been removed. This takes the place of the tab and
your machine can then be engaged in the record-mode.
A "Protected" cassette will prevent the Record key from being pressed. If at any
time you attempt to record and this key will not engage, do not force the mechanism
or damage will result. Check that a cassette has been loaded and that the
erase-lock tab has not been removed.
Remove tab to
protect Side A
Recording
Remove tab to
protect Side B
Recording
Publicité
