Publicité
INSTALLING THE MIRROR
4A. Install the two Lower Mounting Blocks [205-3135] using the supplied washers [SS164] and #10 screws [SS674] as shown.
Note: Supplied wall anchors [203-1349] may be used with Lower Mounting Blocks [205-3135] if a structural frame member is not
available.
4A
[SS164]
Washer
4B. Wall Anchor instructions for Lower Mounting Blocks, if needed:
1. Drill a 5/16" hole into drywall/wallboard, tile, plaster, brick, or concrete.
2. Insert the wall anchor into the hole. Tap until anchor flange is flush with the wall.
3. Insert a #10 screw [SS674] and washer [SS164] through a Lower Mounting Block [205-3135] into each wall anchor [203-1349]
and tighten until contact with the wall is achieved.
4. Continue to tighten screw until there is a strong resistance. DO NOT OVER TIGHTEN.
1
© 2020 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
[SS674]
Screw
2
3
4
4
Part no. 209-1361 10/07/2020
Modular Mirror
Publicité
