Vibbel Khona Press 3 in 1 Mode D'emploi page 4

CONTROL PANEL
1
On / Off button
2
Display screen and parameter control
REAR PANEL
1
1
Air pressure tube connector
2
Electrostimulation connector
3
Thermotherapy connector
4
Electrical power supply connector
5
Fuse
CONNECTION AND ASSEMBLY
INSTRUCTIONS
● Connect the power cable to the rear panel of the
main body.
● Connect the piece coming from the mat (the one
with a mobile revolving cap on one end) to the air
pressure tube connector located on the rear panel
of the main body. Insert the piece and then twist
the cap until it feels tight enough.
● Insert the thermotherapy connector into the back
panel of the main body.
● Insert the electrostimulation connector into the
back panel of the main body.
● Connect the pressure tubes housed within the mat
to the various sections of the suit. A number will
indicate where each tube should be connected.
EN
4
2
1
2 3 4 5
9
7
8
6
5
4
3
2
1
0 0
● Connect the thermotherapy cables housed in the
blanket with the corresponding cables found on
the different sections of the suit. In the previous
section of this manual "Suit. Pressotherapy and
thermotherapy function" it indicates which section
of the suit you should connect to the cables of
the thermotherapy function. The sections can be
identified with the numbers 1 to 5.
● For the use of the electrostimulation function:
- The cables are numbered in pairs. Each pair is
formed of a red and a black cable with the same
number, from 1 to 5.
- Connect each pair of cables to a pair of
electrodes.
- Place each pair of electrodes on the area of the
body that needs treatment, using the correct
sized elastic band, so that they are secure.
● Always apply conductive gel between the electrode
and the skin.
POWER AND CONFIGURATION
● Press the on/off button to start the device. When
it is on, a beep will sound and the welcome screen
will be displayed.
- Press the screen to move to the next display
screen and the parameter control.
9
8
5
4
3
2
1