Scooter Parts Diagram; Folding, Unfolding And Adjusting The Handlebar Height - e-TWOW BOOSTER-V Manuel Utilisateur

5. SCOOTER PARTS DIAGRAM

1. Acceleration lever
2. Power button
3. Settings button
4. 4. On/off light button
5. 5. Horn button
6. 6. Handlebar
7. 7. Controller
8. 8. Folding bar
9. 9. Front fender
10. 10. Battery front cover
11. 11. Protection cover
12. 12. Folding buttons
13. 13. Electromagnetic brake lever
10

6. FOLDING, UNFOLDING AND ADJUSTING THE HANDLEBAR HEIGHT

(a) (b
(d)
Folding steps
• To fold the scooter start by adjusting the handlebar's height to the minimum.
Do this by opening the lock lever as shown in figures (a) and (b).
• Next, press down on the display as shown in figure (d), while also pushing
the height button, as shown in figure (c), to lower the handlebar's height. Push the
lock lever back into lock position.
• Next, press the folding buttons while also while pulling sideways the handle-
bar grips as shown in figure (e) and then fold them downwards.
• Next, press the folding lever in the direction of the arrows, while slightly push-
ing the handlebar forward, as shown in figures (f) and (g)
• Continue folding the scooter until the folding hook enters the opening located
on the rear brake, as shown in figure (h).
(c)
(e) (f)
11