Tensions XC-722 Mode D'emploi page 8

 Ensure the power inverter is sufficiently
ventilated - ventialtion slots must NOT be
covered up.
GB
Ensure you do not overload the power in-
verter. Only connect electrical units that
draw a maximum of 300W. The rated power
of a unit can be found on the mains adapter
or in the unit's handbook.
Operation
CAUTION: Once the unit is connected there
will be a 230V power supply to the output
socket. On no account should you touch the
socket contacts. Keep the socket out of re-
ach of children and do not allow the power
inverter to come into contact with water or
any other liquids.
On/Off switch
Note: Only use the power inverter in the
vehicle when stationary???. Jöllenbeck
GmbH accepts no liability whatsoever for
either the use of the unit whilst in motion or
for fixed installation of the power inverter in-
side the vehicle.
 Before using the power inverter flick the
On/Off switch to position I.
 Flick the On/Off switch to position 0 if
you are not using the power inverter.
This prevents unnecessary current being
drawn from the car battery.
LEDs
 The Power LED (above) shows that the
power inverter is working correctly.
 The Fault LED shows that there is a
fault. Should the Fault LED illuminate,
flick the On/Off switch to position 0 and
then back again to position I. If the LED
continues to illuminate check the fuse.
Further information about this can be
found in the chapter "Changing the fuse".
Changing the fuse
Remove both screws on the fuse cover, then
remove the fuse cover. Remove the old fuse
and replace it with a new one. Make sure
you fit a fuse rated at 40A maximum.
Technical Data
 Model no: XC-722
 Input voltage: 12 Volt
 Output voltage: 230 Volt
 Maximum power output: 300 Watt
 Active cooling
8