Tensions XC-722 Mode D'emploi page 7

Introduction
Thank you for purchasing the 300W power
inverter. With this unit, you'll no longer need
to carry along any other adapters to use
your notebook, mobile phone charger or si-
milar device in the car.
Features
 Mobile power inverter for connection to
the car's 12V power supply
 Converts the car battery's 12V DC
supply to 230V AC 50Hz
 Standard house socket for connecting
electrical units with earthed connector
 Powers up to 300W
 On/Off switch preserves battery life
when not in use
 Status LED
 Overheating safeguard
 Short circuit fuse
 Overload protection up to 40A
 Warning LED for low battery level
 Automatic switch-off for low battery level
Included in the Delivery
 300W power inverter with two
connecting cables
 Operating manual
Connecting the power inverter
Note: Only allow suitably trained and qua-
lified people to install the power inverter.
First Wise Media GmbH accepts no liability
whatsoever for any damage that is caused
or injuries that are sustained as a result of
an incorrect installation.
 Make sure the On/Off switch on the
power inverter is set to Off and that the
vehicle's ignition is off.
 Connect both cables according to their
colours to the power inverter.
 Watch the polarity when connecting to
the car's power supply:
(+12V) red, (earth) black
 Connection should be made only to a
fused section of the car's power supply.
If connecting the power inverter directly
to the car's battery, then an additional
fuse should be integrated to prevent
short-circuits in the circuit. If this is the
case then cut the red (+) cable in two
directly behind the battery and fit a 40A
fuse. This fuse is not included, but is
available as a vehicle accessory.
 When installing, make sure that the
power inverter and the wiring is not
installed near safety systems like airbags
or belt pretensioners etc. and that it
does not interfere in any way with such
systems.
7
GB