Servicing - Wolf Garten LYCOS 40/480 V Mode D'emploi

Servicing

Switching the device on J
The blowing/vacuum speed level can be set using
the continuously adjustable adjustment wheel.
Set the desired blowing/vacuum speed using the
Î
adjustment wheel (1 - 5) 1 .
Press the on/off switch 2 .
Î
3 The device operates.
Turbo mode
The leaf vacuum/leaf blower has an additional turbo
mode for extra high blowing/vacuum speeds.
Press the turbo button, to create a stronger air
Î
blast or vacuum 3 .
Note
Turbo mode remains active after switching
the device off and back on again. To switch
turbo mode off, the turbo button must be
pressed again so that the device can work in
normal mode (slow motor speed).
Working with the device K
Attach the carrying belt to the device and wrap it
Î
round.
Hold the device with one hand on the handle and
Î
the other on the U-shaped grip.
Hold the vacuum/blow pipe a few centimetres
Î
above the ground or move it on the transport
wheel.
Move slowly forwards in a controlled manner.
Î
Note on the motor speed
Use a lower speed for light material and a
higher speed for heavy material.
When to use the blow function
Use in areas which are difficult to clean: e.g. flow-
erbeds, shrubbery, trees, around house corners,
grating and fences.
Perform movements from one side to another.
Î
Keep the collected pile of waste in front of you.
Î
Use turbo mode as necessary.
Î
When to use the vacuum function
For areas which are difficult to clean, such as flower-
beds, shrubbery, house corners, etc.
Perform lateral movements or use the device on
Î
the transport wheel for collecting light material.
Leaves and twigs are vacuumed up and crushed.
The vacuum bag can then hold more material.
Empty the vacuum bag when full.
Î
Switching the device off J
The device switches off as soon as you release the on/
off switch on the handle 4 .
Emptying the vacuum bag
Risk of injuries or material damage.
¾ Before removing/emptying the vacuum
bag, switch off the device and remove
the power pack.
Emptying without removing the vacuum bag
Open the zip on the vacuum bag.
Î
Empty the vacuum bag in accordance with local
Î
regulations.
Close the zip.
Î
Removal of the vacuum bag for emptying
Press the vacuum bag release mechanism 1 .
Î
Pull off the vacuum bag 2 .
Î
Release the vacuum bag fixing hooks 3/4 .
Î
Open the zip on the vacuum bag.
Î
Empty the vacuum bag in accordance with local
Î
regulations.
After emptying the vacuum bag, shake it thor-
Î
oughly to remove dust and dirt from the fabric.
Close the zip and reattach the vacuum bag to the
Î
device.
Removing the power pack M
Press the power pack release 1 .
Î
Remove the power pack 2 .
Î
Servicing
Risk of injuries or material damage.
¾ Maintenance or cleaning work may only
be performed on the device with the
motor at a standstill, the blow/vacuum
turbine stopped and the power pack
removed.
¾ Repair and service work as well as the
replacement of safety elements must
be performed by a qualified expert or
workshop.
WARNING!
WARNING!
EN
L
23