Silverline 974451 Mode D'emploi page 7

974451
4. Unscrew the Drain Cap and allow the liquid to drain. Undo the Lid Clamps (8) and remove the Lid
(9)
5. Tip the rest of the liquid out of the Tank into the drainage area
Blowing
1. Ensure the inside of the Tank (4) and the Filter Frame (14) are clean and free from dirt before
operating
2. Ensure the Foam Filter (23) is clean and dry, and fitted to the Filter Frame
3. Replace the Lid (9) on top of the Tank
4. Close both Lid Clamps (8)
5. Remove the plastic Air Outlet Cover (26) already fitted to the Air Outlet (10). It has a small clip
underneath so press at the underside of the cover before pulling out
6. Attach the Flexible Hose (2) to the Air Outlet
WARNING: Point the small end of the Flexible Hose well away from any object or person; debris
may be ejected from the hose end
7. Switch on the vacuum cleaner by pressing the ON/OFF Switch (12) into the 'I' position
8. Wait a few minutes for waste to be released from the end of the hose before blowing
Accessories
• A range of accessories and consumables, including filters and bags, is available from you
Silverline stockist
• Spare parts can be obtained from toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any inspection,
maintenance or cleaning.
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised Silverline service centre. This advice also applies to extension cords
used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth.
If available, use clean, dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol or
strong cleaning agents
• Never use caustic agents to clean plastic parts
Filter cleaning
Note: A clogged filter will cause suction power and cleaning efficiency to deteriorate. Check
whether the filter is blocked if performance deteriorates.
• Detach the Lid (9), to gain access to the Foam Filter (23)
• Remove and clean the Filter using a brush and dry compressed air
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
1250W Wet & Dry Vacuum Cleaner 30Ltr
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: silverlinetools.com/en-GB/Support
Address:
Powerbox
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
silverlinetools.com
7