Dremel MS20 Consignes De Fonctionnement/Sécurité page 11

DM 2610Z03287 05-13_DM 2610Z03287 05-13.qxp 5/24/13 8:09 AM Page 11
To remove the Moto-Saw for
hand held use
1. Unplug the Moto-Saw.
2. Press the release lock release button at
the rear of the saw station work surface.
3. Slide the Moto-Saw back to release from
the lock mechanism.
4. Pull the Moto-Saw up from the saw station
and pull the cord through the saw station.
Installing Dust Extraction
When connecting tool to dust collection and
extraction systems, be sure these are
connected and used according to tool and
vacuum instructions. Proper use of dust
collection systems maximizes effectiveness.
Do not use dust extraction when working on
metal. Particles from sanding, grinding or
cutting metal may be hot and may spark
which may melt plastic adaptors, vacuum
hoses, and may cause a fire inside the
vacuum bag/tank.
Position vacuum hoses such that you do not
block the power switch. You must maintain
clear access to the ON/OFF switch for full
control.
Your Moto-Saw includes a vacuum dust
adapter. The adaptor can be used to connect
the vacuum hose to either the left or the right
side of the tool, Fig. 11.
The outside of the adaptor can be used to
connect 1 5/8 in. and the inside of the
adapter can be used to connect 1 3/8 in.
1. Attach dust extraction adaptor onto saw
station.
2. Attach vacuum hose to vacuum adaptor.
To remove, reverse instructions.
FIG. 10
FIG. 11
11