Publicité
Les langues disponibles
Les langues disponibles
0～40°C adjustable thermostat to control the room temperature，the thermostat button can
be turned from 0 to 270 degree.
THERMOSTAT INSTRUCTIONS
At first turn the thermostat to "Max" and let the heater operate with full power input. When the
room temperature reaches the required value, turn the thermostat to left until it switches off.
The thermostat will then switch on and off automatic to control the room temperature
according to the preset value and keep the room temperature constant.
Manual reset thermal cut-out
By overheating or abnormal operation and meanwhile the thermostat fails to work, the
manual resetting thermal cut-out will act and shut down the appliance. Remove the plug from
the socket and let the appliance cool down, then use the provided steel pin to touch the
manual resetting button. When you hear a clear click it means the electric circuit is put
through, put the plug back into the socket and switch the heater on.（see the figure manual
"RESET" button）
When using the heater for the first time, you may notice a slight emission of smoke. This is
quite normal and it stops after a short time. The heating element is made of steel and was
coated with a layer of protection oil by production. The smoke is caused by the left oil when
heated.
After the use turn the thermostat to OFF position and turn the selector switch to Fan level, let
the appliance cool down for two minutes. For appliances with time delay stopping function,
even the power switch is off。
If the fan heater is to be permanently installed, the following instructions must be observed:
Publicité
