Publicité
STEP 8
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper
diagram below. Be prepared, the parts are greasy.
Fasten one EXTENSION RAIL (1) to the RIGHT END (G). Use three 1/2" FLAT HEAD SCREWS (23).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1st hole shown in the diagram.
å
Then, slide the inner cartridge of the EXTENSION RAIL in to find the other holes that line up
with the holes in the END. Turn a SCREW into each hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWER.
Open end
2
Push the black lever and pull
the SLIDE from the RAIL.
Page 14
1/2" FLAT HEAD SCREW
G
1
Open end
429421
1
23
(3 used in this step)
1
st
1
st
The large hole
must be here.
whiskersupport.com
Publicité
