Publicité
Les langues disponibles
Les langues disponibles
Care and Cleaning
w WARNING
• Handle blade carefully; it is very sharp.
• Make sure unit is turned
• Always unplug unit before cleaning.
w WARNING
immerse cord, plug, or base in any liquid.
To Use CLEAN Cycle
1. Remove all processed food from Bowl.
2. Place Stainless Steel Chopping Blade into
Bowl.
3. Fill Bowl with WARM water up to CLEAN
Line. Do not use HOT water as it can cause
an overflow.
4. Insert Agitator Disc
into Bowl, rotate
until Disc is seated,
and add soap to
Soap Dispensing
Wells. Fill one
Soap Dispensing
Well for normal cleaning and fill both Soap
Dispensing Wells for oily or sticky foods
such as hummus, nut butter or cheese. Do
not overfill wells with soap. Each well holds
about 1/4 teaspoon liquid soap.
5. If Reversible Slicing/Shredding Disc needs
cleaning, place in Bowl with dirty side
facing down before assembling Lid and
Food Pusher. Add Lid and both Large and
Small Food Pushers. Clip Lid. Always install
Food Pushers before pressing CLEAN
button.
Laceration Hazard.
(Off) and is unplugged.
Electrical Shock Hazard. Disconnect power before cleaning. Do not
6. Push CLEAN button. The automatic Quick
Clean™ cycle will begin. Cleaning cycle
runs for approximately 30 seconds. You
may press STOP/START to end the cycle
early.
7. When cycle ends, carefully rinse each
component.
w WARNING
suds can make it difficult to see the blades.
Pour the soapy water out of the feed chute
before removing the lid.
NOTES:
• The seal on the Bowl may need to be
cleaned by hand, if soiled while removing
food from Bowl.
• It is normal for a small amount of liquid
and soap to spill over the top of the feed
chute. This is helpful in cleaning the chute.
• If any residue remains, wash by hand in
hot, soapy water or place in dishwasher.
DO NOT use the "SANITIZE" setting as
these temperatures could damage your
product.
10
Laceration Hazard. Soap
Publicité
