General Instructions; Understanding Your Iquartz Safety Seat; Prior Adjustments; Checking The Height Of The Shoulder Straps - JANE iquartz Mode D'emploi

C. GENERAL INSTRUCTIONS
In order to protect the child properly, and ensure that he is comfortable and secure in the
car, the following instructions must be followed:
• Your iQUARTZ safety seat has been designed to be installed on the front or back seats of
the vehicle, provided that the seats are fitted with a 3-point seat belt. However, we recom-
mend that you install the safety seat, whenever possible, on the back seat of the vehicle, as
this ensures maximum safety.
• It is only suitable for use in vehicles fitted with automatic 3-point seat belts, that have been
approved under Standard ECE R16 or other equivalent standards. Do NOT use with a 2-point
seat belt, as this would be very dangerous in the event of sharp braking or an accident.
• In some cars the buckle strap is quite far forward, so it may come into contact with the edge
of the booster seat, which is not safe. In this case, try moving the vehicle seat forward or
install the safety seat somewhere else in the vehicle.
• Not all safety systems are exactly the same, therefore we advise you to test your
iQUARTZ in the vehicle in which it is going to be installed.
• It is very important not to use second hand products, because JANÉ can only guarantee
complete safety for articles used by the original buyer.
• JANÉ recommends you replace your iQUARTZ safety seat with a new one if it has been
involved in an accident.
• Check that all the straps are in the correct position and properly fitted to your iQUARTZ.
Make sure that none of them are twisted.
• Make sure the child understands that he must never tamper with the belts or the fastenings.
• iQUARTZ is designed for use in the car, it must not be used out of the vehicle.
• For more information on the use and installation of the iQUARTZ consult our web page
www.jane.es.
IM-2004,01 iQUARTZ text esp modificado.indd 21
D. UNDERSTANDING YOUR iQUARTZ SAFETY SEAT
Your iQUARTZ safety seat has been designed using the latest advances in safety and has been
tested under the strictest of conditions. It has the following features:
To improve the child's safety:
• Vehicle attachment system using ISOfix anchors. These are only used to fasten the safety
seat to the vehicle seat, the child should be fastened in with the vehicle 3-point seat belt.
• Headrest with 11 different height positions to protect the child as he grows.
• Higher sides, providing more protection against side impact.
• Shock absorbing material on the sides and middle of the headrest.
• Reinforced headrest to withstand deformation.
To improve the comfort and fit for the child:
OK
• Reclining seat, with 3 different positions.
• Extra padding.
E. PRIOR ADJUSTMENTS

Checking the height of the shoulder straps.

WARNING: To guarantee maximum safety for the child, the seat belt should go just abo-
!
ve his shoulders.
Place the child in the iQUARTZ and make sure he is sitting correctly. The seat belt should go
just above the child's shoulder.
To adjust the height, pull the button placed behind the headrest (5) and slide the backrest to
the required position. When it is positioned at the right height, release the button and adjust
the headrest to the nearest locking position.
1a
1b
EN 21 21
19/1/18 13:20