Assembly - BE AC203C Mode D'emploi

FEATURES (AC205C)
Read this operator's manual and safety rules
before operating your compressor.
7.
8.
9.
1. Pump Head
2. Air Filter
3. Fan Cover
4. Release Valve
5. Pressure Gauge
6. Regulator
7. Air Tank
8. Unloading Pipe
9. Discharge Valve
10. Feet
11. Sight Glass
16
6. 3.
5.
2.
1.
4.
11.
10.
6.

ASSEMBLY

Assembly
Read all safety instructions before using air compressor.
WARNING
The compressor is shipped without oil in the crankcase.
Add oil as indicated below.
Oil Level OK
Check Oil
Level Daily
Refill Oil
Immediately
1. After opening the carton, please remove all parts and compare with
the photograph on box/carton. If any parts are missing, please call our
support line at 1-866-850-6662.
2. Place air compressor on a flat, level surface.
3. Pour supplied oil into crankcase until the oil level reaches the red dot in
the oil level sight glass. Be careful not to overfill.
4. Install oil fill plug, supplied for compressor operation, before starting
compressor.
5. Close tank drain valve on the bottom of the air tank by turning the valve
clockwise until fully closed.
6. Attach the air coupler to the compressor regulator valve. Use Teflon
thread-sealing tape on the threads to make sure you have an airtight
connection. Do not over-tighten fittings.
7. Attach the supplied air filter to the air intake port on the pump head.
8. Attach air hose and any desired air accessories (not included). Use
Teflon thread-sealing tape on the threads to make sure you have an
airtight connection. Do not over-tighten fittings.
NOTICE
Do not operate the compressor without lubricant or with low lubricant
level. We are not responsible for damage caused to the compressor
due to operation without proper lubrication.
17