Table des Matières
Publicité
Liens rapides
Publicité
Table des Matières
Manuels Connexes pour BE AC203C
Sommaire des Matières pour BE AC203C
- Page 1 PORTABLE AIR COMPRESSOR AC203C AC205C USER MANUAL...
-
Page 2: Table Des Matières
12 Hose Precautions Installation & Grounding 13 Installation and Location 13 Grounding Instructions 14 Extension Cords Features 15 AC203C Air Compressor Features 16 AC205C Air Compressor Features Assembly 17 Assembly Instructions Operation 18 Preparation for Starting 19 Operation and Adjustment... -
Page 3: Introduction
20 Maintenance Caution 21 Caution Using the Operator’s manual Thank you for purchasing a BE Air Compressor. Please take time now Exploded View to read through this manual so you better understand the machine’s 22 Exploded View Diagram (AC203C) operation, maintenance and safety precautions. -
Page 4: Product Identification
Date of Purchase: If you discover damage after receiving the air compressor (concealed Dealer Name: damage), the carrier must be notified within 15 days of receipt and an inspection must be requested by telephone with confirmation in writing. Dealer Phone: On concealed damage claims, the burden of establishing that the compressor was damaged in transit reverts back to the claimant. -
Page 5: Air Tank Warning
Do not direct paint or other spray material towards the compressor. Read and follow all safely instructions for the material you are spraying. Be sure to use an approved respirator designed for use with your specific application. WARNING... -
Page 6: Electric Shock Warning
1. Read all manuals included with this product carefully. Be thoroughly familiar with the controls and the proper use of the equipment. This air compressor is powered by electricity and should never be used 2. Follow all local electrical and safety codes. -
Page 7: Spraying Precautions
NSTALLATION AND LOCATION rupture or explosion. Always replace worn or damaged tanks. Drain The compressor must be used on a stable and level surface. It must also liquid from tank daily. be used in a clean and well-ventilated area. The compressor requires an 13. -
Page 8: Extension Cords
Be sure your extension cord is rated to allow sufficient flow to motor. Refer to the guide for minimum gauge required for extension cords. Extension Cord Length Wire Size (A.W.C.) -
Page 9: Assembly
2. Place air compressor on a flat, level surface. 3. Pour supplied oil into crankcase until the oil level reaches the red dot in the oil level sight glass. Be careful not to overfill. 4. Install oil fill plug, supplied for compressor operation, before starting compressor. -
Page 10: Operation
This is the necessary condition 1. Pump is shipped with oil. Remove the oil cap and check pump oil 1. Place the compressor on a clean, dry, and ventilated surface. for restart, or the motor will be damaged. The rated pressure can be level. Add SAE 30 non-detergent pump oil (Part #4043), if neces- 2. Keep the voltage used within±5% of rating. - Page 11 Disconnect electrical cord from outlet and release air pressure cause immediately so as not to damage motor. from system before performing maintenance. 8. Lubricating oil must be clean, and the oil level should always remain at the red mark in the sight glass. NOTICE 9.
- Page 12 EXPLODED VIEW (AC203C) EXPLODED VIEW LIST (AC203C) PART NAME QTY. PART NAME QTY. TANK WASHER CONNECTION BOLT FERRULE SEALING CYLINDER METAL TUBE 0.12 SPRING WASHER BOLT BOLT WASHER CONNECTION ROD RUBBER FOOT CIRCLIP DRAIN VALVE PISTON CHECK VALVE PISTON RING...
- Page 13 EXPLODED VIEW (AC205C) EXPLODED VIEW LIST (AC205C) PART NAME QTY. PART NAME QTY. TANK SPRING WASHER FERRULE SEALING METAL TUBE 0.12 CYLINDER DRAIN VALVE SPRING WASHER BOLT RUBBER FOOT CONNECTION ROD WASHER CIRCLIP SPRING WASHER VALVE REED OIL LENS SEALING BOLT HEAD O-RING...
- Page 14 TROUBLESHOOTING NOTES Troubleshooting Chart If you are experiencing a problem that is not listed in this chart, or have checked all the possible solutions listed and you are still experiencing the problem, see your authorized dealer. Trouble Possible causes Remedies Motor unable to 1.
- Page 15 THE POWER YOU NEED. If you need assistance with the assembly or operation of your Compressor, please call 1-866-850-6662...