Publicité
Les langues disponibles
Les langues disponibles
• Double check to make sure the filters are not broken or
torn. Do not use filters that are broken or torn. Handle the
filters carefully when removing and installing.
• To reduce the risk of hearing loss associated with sound
level(s), hearing protection is required.
• Always direct the cord backwards, away from the unit.
• This unit is intended for indoor use only. Do not use this
unit outdoors.
• Be extremely careful when working on slopes and stairs.
• Always move forward by walking. Never run.
• Clean up after using the wet/dry vacuum. Dispose of
debris appropriately.
• Always use the handle for transporting the equipment.
m
WARNING!
To avoid personal injury, wear ear
protectors when operating this unit. Wear a face mask or dust
mask in dusty locations.
Air Inlet
Never cover the air inlets. Keep them free from obstructions
and debris. They must always remain clear for proper
motor cooling.
m
WARNING!
To avoid personal injury, do not wear loose
fitting clothing or articles such as scarves, necklaces, chains,
ties, etc., that could get drawn into the air inlet. To make sure
long hair does not get drawn into the air inlet, tie back
long hair.
Basic Vacuum Procedures
m
WARNING!
Do not vacuum drywall dust, fireplace soot
or ash with the unit. This is very fine dust which will not be
captured by the filter and may cause damage to motor.
m
WARNING!
The HEPA filter is only for dry vacuum.
Make sure the HEPA filter is attached for dry cleaning,
and DO NOT use the HEPA filter when vacuuming liquid.
m
WARNING!
The foam filter must be used for wet
vacuuming, and make sure to clean the foam filter after
wet vacuuming.
• Place the equipment on a level surface that is not
heat sensitive.
• Always use the vacuum hose for vacuuming. Hold the
vacuum hose at a distance of approximately 0.4 in. (1 cm)
above the material to be vacuumed.
m
WARNING!
When vacuuming large quantities of liquids,
do not immerse the brush attachment completely in the liquid;
leave a gap at the tip of the brush attachment opening to allow
air inflow. The machine is fitted with a float valve that stops the
suction action when the collection tank reaches its maximum
capacity. You will notice a decrease in motor speed. When this
happens, turn off the machine, disconnect from power supply,
and drain the liquid into a suitable receptacle or drain.
To continue vacuuming, refit the collection tank with the
power head.
• To prevent overheating of the motor, stop the unit for one
minute after every 15 minutes of using.
• Turn off and unplug the unit after vacuuming, before
cleaning and maintenance. After wet vacuuming, empty
the collection tank, clean and dry the inside and outside
before storage.
• Empty the tank outside in order to avoid a mess.
• Clean or change the filters (see Maintenance section) if the
suction performance deteriorates.
m
WARNING!
Never remove the power head without
first turning the power switch to the OFF (O) position and
unplugging the unit from the main power source.
Air Flow Regulating Block
• Used for the auxiliary regulation of suction force; when
the air flow regulating block opens, suction will decrease
gradually (Fig. 8).
• When the air flow regulating block is closed, the suction
force reaches the maximum value.
Fig. 8
Air flow
regulating
block
9
Publicité
