I Cleaning And Maintenance - Leifheit REGULUS AQUA POWERVAC Mode D'emploi

CLEANING THE FLOOR
Figure 7
To switch on the appliance, press the On / Off button (1) once.
The operating display illuminates green after switching on.
Optional: Press the vacuum mode button (2) once in order
to the turbo mode if tiled / stone floors have more stubborn
dirt. Then the operating display flashes green slowly. Switch
back to Eco mode by pressing the vacuum button again.
Figure 8
Tilt the appliance to the rear to release it from the stand
position.
Figure 9
Press the water lever (3) to moisten the cleaning roller
(20) as needed
Before starting to clean the floor, keep the water
lever pressed for several seconds without moving the
appliance in order to quickly and evenly moisten the
roller in advance.
To clean the floor, push the appliance back and forth
in steady and equal movements.
If the moisture of the cleaning roller reduces, press the
water lever again and keep it pressed until the desired
moisture is reached again.
The fill level of the dirty water tank (7) must not exceed
the maximum fill level.
Figure 10
During cleaning breaks, always place the appliance at
the corresponding park station (22) in order to avoid the
formation of water stains to the floor from the residual
water in the appliance.
Figure 11
Once the dirty water tank (7) is filled to the Max. line,
a notification system ( k Tank Control Technology) is
activated. As a result, the operating display (10) flashes
orange and the cleaning roller stops 3 times for a few
seconds and then the roller stops completely.
Now the dirty water tank must be emptied at the latest.
Cleaning and
I
maintenance
EMPTY THE DIRTY WATER TANK AND CLEAN THE FILTER
Figure 12
To switch off the appliance, press the On / Off button (1)
once again.
Remove the dirty water tank (7).
For this purpose, press the release button (11) down and pull
the tank out on handle (30).
Figure 13
Lift the cover (27) from the dirty water tank (7).
Empty the dirty water tank.
Figure 14
Remove the sponge filter holder (25) from the cover of the
dirty water tank (27).
Remove the sponge filter (26) from the sponge filter holder.
Figure 15
Depending on the degree of soiling, rinse out all parts
of the dirty water tank unit (7, 25, 26, 27, 28, 30) under
running water.
Figure 16
Before putting back together and insertion of the parts
removed, allow all parts to completely dry in the air.
CAUTION: To avoid the formation of odour,
remove the dirty water tank unit after use and
rinse out. Insert only completely dried parts
back in the appliance.
Figure 17
Reassemble the sponge filter (26), sponge filter holder (25),
cover (27) and dirty water tank (7).
Figure 18
Reinsert the dirty water tank back into the appliance until
you hear it engaging.
15