Fitting Cd4000 To Door - Bewator CD3500 Manuel D'installation Et De L'utilisateur

10

Fitting CD4000 to door

1 1
3 3
4 4
CD3500 & CD4000 Installation and User manual
1. Remove the cylinder ring
and the door handle from
the door by loosening
the four screws. The lever
handle spindle
project no more than 20
mm on the outside of the
door. If the spindle is too
long, push it through into
the handle on the inside.
If this cannot be done, cut
the spindle to the right
length.
2. Screw the supplied extension sleeves to the nipples
for the handle. Use the appropriate size sleeve to
suite the bolts supplied with the handles.
3. Place Codoor on the outside of the door with
the handle attached, and pass the lever handle
spindle through the
square hole. Note: The
red mark on the follower
should always point
upwards.
4. Tighten, not too hard, the
four previously loosened
screws (the screws for
the handle first).
should
RED RED
2 2
5 5