Operating The C01U; Powering The C01U; Polar Pattern; Microphone Placement - Samson Audio C01U Mode D'emploi

Operating the C01U

Powering the C01U

The C01U is a condenser microphone, and like all condenser microphones, it has
internal electronics that require an active power supply. Traditional studio condensers
are almost always powered by a Phantom Power supply which is usually derived from
the mixing console. The C01U receives its power from the USB bus. Simply connect
the microphone to the computers USB port and the microphone is ready to operate.
The C01U features a power on LED, which will illuminate when USB power is present.

Polar Pattern

The most important characteristic of any microphone is its directionality or "pick-up
pattern". There are three basic categories of pick up patterns; omni, bi and uni-direc-
tional. Omni mics pick up sound from all directions, bi-directional (figure 8) mics pick
up the sound directly in front and back of the microphone while rejecting the sound
on the left and right sides, and uni-directional (cardioid) mics pick up the sound in
front of the microphone.
While omni and bi-directional microphones are very useful for a variety of applica-
tions, the majority of "miking" situations in recording and live sound require uni-
directional or cardioid microphones. The uni-directional nature allows for better
separation of instruments in the studio and more control over feedback in live sound
reinforcement. The C01U condenser's pick-up pattern is hyper-cardioid, which offers
even more side-to-side rejection. When positioned correctly the hyper-cardioid pick-
up pattern allows you to pick up more of the sound you want and less of the sound
you don't want.

Microphone Placement

In order to maximize the sound quality, you must pay careful attention to the place-
ment of your C01U and how it is positioned for the instrument or vocalist that you are
miking. All microphones, especially uni-directional or cardioid microphones, exhibit a
phenomenon known as "proximity effect. " Very simply put, proximity effect is a result-
ing change in the frequency response of a microphone based on the position of the
mic capsule relative to the sound source. Specifically, when you point a cardioid mic
directly at the sound source (on axis) you will get the best frequency response, how-
ever when you start pointing the microphone slightly away (off axis) you will notice
the low frequency response dropping off and the microphone will start to sound
thinner.
For most vocal applications you'll want to position the microphone directly in front of
the artist. The same may be true for miking instruments, however, you
7