Greencut LJ400C Manuel D'utilisation page 57

BEVEL SANDING WITH ANGLE GAUGE
NOTE: An angle calibrator is included to improve accuracy. For sanding small surfaces on the
sanding disc, the use of a miter bracket is recommended.
ATTENTION: Always move the workpiece through the sanding disc from the left to the centre.
Miter Calibrator
HORIZONTAL AND VERTICAL SANDING
The machine can sand both vertically and horizontally. Depending on the workpiece, use the work stand for horizontal
sanding operations and the support table for vertical sanding operations.
1. Using the Allen key provided, loosen the positioning bolt by turning it counterclockwise.
2. Lift the end of the sanding belt to a vertical position.
3. Lock the sanding belt by retightening the positioning bolt.
ATTENTION: Always use the work stand for horizontal sanding and the work table for vertical
sanding. Sand long workpieces with the sanding belt in vertical position by moving the workpiece
evenly across the sanding belt.
Directional
arrows
Vertical position
Horizontal position
Positioning bolt
Directional
arrows
Miter Calibrator
57
EN