Assembly - Greencut LJ400C Manuel D'utilisation

54

ASSEMBLY

ATTENTION: Do not connect the machine to the power supply until the assembly is complete.
Failure to comply could result in serious injury.
WORKING TABLE OF THE DISC SANDER
1. Insert the clamp bolt of the work table into the hole in the tool
housing.
2. Place a washer over the table lock knob and then firmly tighten
the table lock knob.
BELT SANDER WORKING TABLE
1. Insert the index pin of the work table into the hole in the sanding belt arm.
2. Place a washer over the table lock knob and then firmly tighten
the table lock knob.
WORK SUPPORT
1. Place the work stand over the holes on the side of the sanding belt arm.
2. Using an Allen wrench, replace the washers and socket head screws.
Washer
Tornillos Allen
Pin
Perilla de bloqueo
de la mesa
Mesa de
trabajo
Mesa de
Pin
trabajo
Washer
Perilla de bloqueo
de la mesa
Mesa de
trabajo
Washer