Mr Maria MRLED8 Mode D'emploi page 4

EN
USER MANUAL
This Remote Kit contains everything you need to operate your
Mr Maria lamp with a remote control. The Mr Maria Remote works
best when used from a distance between 1,5 and 3 meters.
PACKAGE CONTENTS
• Mr Maria Remote incl. CR2032 battery (fig.1)
• LED light source (MRLED8), 2700 Kelvin and max. 270 Lumen
• Power cable
• Optional: adapter block (low voltage)
• This manual
MAKE IT SHINE
1. The new LED light source contains a receptor for the signal of
the Mr Maria Remote. Therefore first replace the current LED
light source with the new one and use the same three screws
to hold the LED lamp in place.
2. Unscrew the strain relief from the LED light source, using a
Philips screwdriver (not included), and plug the cable into the
DC port. Reattach the strain relief in order to fixate the con-
nected parts. (fig. 2)
3. Connect the power cable to the adapter block and plug the Mr
Maria lamp into a power socket. A green light will illuminate on
the LED light to indicate that all parts are working.Connect the
USB cable to the USB adapter plug.
4. Remove the plastic from the backside of the Mr Maria Remote
to make it ready to use.
5. Make it shine! Use the button to switch the lamp on.
Read more about the controls on the right.
CONTROLS
ON/OFF - Use button
DIM - Use button (+) and (-) to make the light dimmer or
brighter respectively.
Button The light will gradually turn on within 15 minutes.
Button The light fades out in 5 minutes.
Button The light fades out in 15 minutes.
Button The light fades out in 30 minutes.
WARRANTY
There's a 24 month warranty on your Mr Maria design*.
Please contact our customer service if you have any questions.
Find us at www.mrmaria.com.
* valid when the design is used correctly as described in this manual.
WARNING!
» The product is not a toy and must be used under the supervision
of an adult at all times.
» The product contains particles. Make sure they are correct-
ly attached and keep it away from children.
» The remote control contains a small battery. Make sure the
battery cover is properly closed and secured with the screw. The
remote control is not a toy and should be kept away from children
at all times.
» This lamp should be used indoors and is not waterproof. Do not
immerse in water.
» When cleaning the article always disconnect the adapter from
the power socket. Clean the product with a duster or with a damp
cloth.
» Do not use an USB cable or adapter other than the one supplied.
» Keep the packaging out of reach of children.
» In case of malfunction, do not disassemble the LED module itself.
» When replacing the light source: follow the manufacturer's
instructions and use only original parts. For replacement, always
first remove the adapter from the socket and the cable from the
LED light source.
» Save this manual for later reference.
Caution! The Mr Maria light object is NOT a toy. For proper and
safe use we ask you to read the following instructions before
installation and use of the product.
THE SYMBOLS
A reference to this manual.
The Mr LED8 module is an electronic device and does not belong
in the household rubbish but should be disposed of at the place
indicated by your municipality.
Symbol for Class III appliance.
This s ymbol on the bottom of the unit Mr Led8 means that the
device operates on extra low voltage which is less than 50 volts
alternating current.
Symbol indicating that this product is CE, FCC, KC, RCM, REACH
& RoHS
approved.