Publicité
Les langues disponibles
Les langues disponibles
To reduce the risk of injury, anyone using, repairing, maintaining, or changing accessories on this tool must
read and understand these instructions before performing any of these tasks.
Some dust created by power sanding, sawing, grinding, drilling
and other construction activities contains chemicals known to
the State of California to cause cancer and birth defects or other
reproductive harm. Some examples of these chemicals are:
-
Lead from lead based paints
-
Crystalline silica bricks and cement and other
masonry products
-
Arsenic and chromium from chemically-treated lumber
Your risk from these exposures varies, depending on how often
you do this type of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and work with approved
safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
Handling the brass parts of this product will expose you to lead, a
chemical known to the State of California to cause birth defects
and other reproductive harm. Wash hands after handling.
Air
Length of Pipe (ft.)
Flow
CFM
50
100
3/4"
10
1/2"
3/4"
20
3/4"
3/4"
30
3/4"
1"
40
1"
1"
50
1"
1"
70
1"
Never mount oil and water extractor on or near the air com pres sor.
During compression, air temperature is greatly increased. As the air cools down to room tem per a ture, moisture condenses in the air line, on
its way to the spray gun. Therefore, always mount the oil and water extractor at a point in the air supply system where the compressed air
temperature is lowest.
Drain air lines properly.
Pitch all air lines back towards the com pres sor so that con densed mois ture will flow back into the air receiver where it can be drained off.
Each low point in an air line acts as a water trap. Such points should be fitted with an easily accessible drain. See diagram above.
SAFETY INSTRUCTIONS - DO NOT DISCARD - GIVE TO USER
SX76: Parts Breakdown & Operating Manual
WARNING
AIR SUPPLY
150
200
3/4"
3/4"
3/4"
3/4"
1"
1"
1"
1"
Drain
1"
1"
1-1/4"
1-1/4"
( CONTINUED )
iMPortANt PrecAutioN iNforMAtioN -
reAd before usiNg tHis sPrAy guN:
sPrAy guN descriPtioN
The SX76 is a light weight, general purpose conventional spray
gun designed for use in various types of spraying applications.
iMPortANt: This spray gun may be used with most common
coating and finishing materials. It is designed for use with mildly
corrosive and non-abrasive materials. If used with other high
corrosive or abrasive materials, it must be expected that frequent
and thorough cleaning will be required and the necessity for
replacement of parts will be increased.
Pitch pipe back
toward air receiver
Compressor Unit
Oil and Water Extractor should be at least 25 ft.
from the compressor, farther if possible.
3
Install drain at
each low point
Oil & Water
Extractor
25 Feet
or More
01/07/13
Drain
Publicité
