Napa 815-6241 Instructions De Montage

ASSEMBLY INSTRUCTIONS
. Connect bottom support frame (#6) into top support frame (#3).
Insert small screw (#4) through top support frame (#3) hole and tighten. Repeat on opposite side.
2. Insert casters (#5) from underneath into 4 bottom frame holes.
3. Place plastic tool tray (#7) on top of bottom support frame and align with 4 caster holes.
4. Insert hex screws (#8) from the top into caster holes and tighten.
5. Attach drawer assy. (#2) to top support frame arms and insert screws (#9) from underneath and tighten.
Repeat on opposite side.
6. Place padded seat (#) on top support frame arms. Insert screw (#0) into center hole and tighten.
Repeat on opposite side.
Care Instructions:
DO NOT use harsh chemicals to clean seat.
815-6241 Parts Breakdown & Operating Manual
Ref. # Part# Description
. Padded Seat
2. Drawer Assy.
3. Top Support Frame
4. M5 Screw
5. * Caster
6. Bottom Support Frame 
7. Plastic Tool Tray
8. RS624CHK Hex Screw Kit (set of 4) 
9. M8 Screw
0. M6 Screw
Only Ref.#'s identified by Part# are available for
purchase separately.
* Replacements available as part# BK720-272
 (pair) of casters with nyloc nuts and washers.
For this model, discard hardware that is
packaged with replacement casters. If
hardware is needed to attach replacement
casters, purchase RS624CHK. (hardware for
4 casters)

815-6241
CREEPER SEAT WITH
STORAGE DRAWER
Qty.


2
2
4

4
2
rev. 09/28/07