Ga.Ma GC542 Sport Manuel De L'utilisateur page 10

CUTTING LENGTH ADJUSTMENT:
The GC542 Sport hair clipper offers the possibility of making finishing touches of 0.8 mm (if used without any
guide comb attached) and performing classic hair cuts with the following lengths: 1/2/3/4/5/6/7/8/9/10/11/
12/13/14/15/16/17/18/19/20/21/22/23/24 mm. To change the cutting length, once the comb has been
inserted on the hair clipper, turn the adjusting wheel found on the body of the product to the left until achieving
the desired height (Fig. 3). The cutting length can be displayed in the window above the wheel (Fig.4). To
decrease the cutting length, turn the wheel in the opposite direction, i.e. to the right.
THINNING FUNCTION:
The GC542 Sport hair clipper has a hair trimming function to reduce hair
volume. To use this function move the switch found on the body of the
product to the left, until the comb which protrudes from the inside of the
product is completely raised (Fig. 5). After using the thinning function,
move the switch towards the opposite side, i.e. to the right.
Fig.5
Fig.3
18
CLEANING AND MAINTENANCE:
A clean and properly lubricated hair clipper considerably improves its capacity and cutting precision.
DO NOT CLEAN ANY PART OF THE APPLIANCE UNDER RUNNING WATER.
CLEANING THE HEAD:
Before any cleaning operation, make sure that the appliance is properly turned off and disconnected from the
power outlet.
Remove the accessory if it is inserted.
Remove the head by pressing lightly in the opposite direction to the snap in (Fig.6).
Using the special brush supplied, remove any hair residues inside the appliance body, between the blades
and the back of the head. Replace the head in the initial position, snapping it in until you hear the click.
Fig.4
Fig.6
19