Campbell Hausfeld 1 HP Instructions D'utilisation Et De Montage page 10

Operating Instructions and Assembly Instructions
Airless Paint Sprayers
CLEANUP FOR CHANGING PAINTS
OR TEMPORARY STORAGE FOR
MORE THAN ONE NIGHT (Continued)
17. Lift suction assembly above fluid
level. Allow pump to run until
empty. Make sure prime/spray
control is in SPRAY position to
reduce dribbling.
18. Reduce pressure to lowest setting by
turning pressure control fully
COUNTERCLOCKWISE.
19. Turn power switch to OFF position.
20. With gun pointed in safe direction
pull trigger with lock released to
relieve any pressure in hose.
21. Engage gun trigger lock.
22. Clean buckets and dispose of any
waste paint and solvent in an
environmentally responsible
manner.
23. Clean tip guard with cleaning brush
and solvent.
NOTE: At this point, pump, hose and
spray gun are clean, but still require
further preparation for storage of more
than one day.
www.chpower.com
Finishing Touches/Shutdown
17
Prime/Spray is
in SPRAY
Position
19
Power
Switch
Turn Power
Switch to OFF
Position
10
18
Turn Pressure Control Fully
COUNTERCLOCKWISE
20
Pull Gun Trigger with
Trigger Lock Released