Publicité
Les langues disponibles
Les langues disponibles
Part A-Positive LCD
A1: Radio Controlled icon
A2: Hours and minutes of Time
A3: Indoor Temperature
A4: Calendar
A5: Day of the week
Part B – Buttons and Framework
B1: "SNOOZE" touch position
B3: " " button
B5: "▼" button
B7: " " button
B9: Support frame
Part C –Wireless Remote Sensor:
C1: Battery compartment
Initial operation:
•
Open the clock battery compartment cover
•
Insert 2 x AA batteries observing polarity [ "+" and "-" marks]
•
When you insert the batteries, all the icon on the LCD display will briefly light up for 3
seconds, and you will hear a beep tone, At the same time into work mode， and detect indoor
temperature.
•
The Main Unit will now start to make a connection to the Remote Sensor. This operation
takes about 3 minutes and is displayed by a flashing reception RF antenna symbol in the
"OUTDOOR" display area on the receiver.
•
This now, replace Wireless Remote Sensor battery compartment cover Insert 2 x AAA
batteries observing polarity [ "+" and "–" marks]
Note: The Main Unit searches for the synchronization signal of the outdoor remote sensor
for 3 minutes. Please let the remote sensor power on as much as possible within three
minutes to prevent the reception time from being missed.
•
After the main unit establishes a connection with the remote sensor, it will automatically
enter the radio control time reception mode.
Note: If the Main Unit does not establish a link with the outdoor sensor, it will automatically
enter the receiving mode of the radio control time after 3 minutes.
A6: Outdoor Temperature
A7: Alarm2 icon
A8: Alarm1 turn on icon
A9: DST Icon
B2: " " button
B4: "▲" button
B6: " " button
B8: Hanging hole
B10: Battery compartment
Publicité
